Autodesk Design Suite 3D - Planix Home Design Suite 3D Wartungshandbuch PDF herunterladen (Seite 98)

Using Drafting Settings

To use AutoTrack for object snap tracking

Steps

Use

to look up

Start by drawing a line or polyline in your drawing,

such as the line shown here.

You will use AutoTrack to draw another line based

on the snap points of this line.

Turn on a running object snap like ENDPOINT by

using the Drafting Settings command on the Tools

menu.

Turn on AutoTrack by depressing the OTRACK

button on the Status Bar.

Using AutoTrack

Run a drawing command, like LINE.

When you are prompted to select a point, hold

your cursor over one end point on the original line

you drew in step 1, but do not click.

A small plus sign (+) is displayed over the point.

Move your cursor to a second end point on the

original line you drew in step 1, but do not click.

A small plus sign (+) is displayed over the second

point.

Move your cursor to locate an alignment point, as

shown in the following illustration:

Click to place the start point of the line at this

location that AutoTrack identified.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 284 285

Keine Kommentare

Autodesk Design Suite 3D - Planix Home Design Suite 3D Wartungshandbuch Seite 98